44
docs.carbide3d.com
45
Required Components
See
Figure 8‑2
:
Item
Description
Location
Qty
A
Compact Router
Compact Router Box
1
B
Cable Ties
Shapeoko 3 Final Assembly Box
7
C
#201 ¼-inch Square End Mill Cutter
Shapeoko 3 Final Assembly Box
1
D
Sweepy Dust Boot
Sweepy Box
1
Required Tools
See
Figure 8‑3
:
Item Description
Qty
A
4mm Hex Key
1
B
Flush Cut Pliers or Scissors (not
included)
1
C
13mm Wrench*
1
D
22mm Wrench*
1
*Found in the Carbide Compact Router box.
Install the Compact Router
The router mount supports a 65mm or 69mm
diameter router. 65mm routers, including the Carbide
Compact Router, require the use of the router mount
adapter ring (inserted in step 3).
Before installing any router, the Z-carriage must be
lowered. To lower, press down on the top edge of the
Z-carriage plate, in front of the linear rails, with your
thumbs (completed in step 3).
1.
Use the 4mm hex key to loosen the two (2)
M5
×
55mm socket head cap screws on the front
of the router mount.
2. Insert the router into the mount until the taper of
the router’s body meets the adapter ring. Extend
the power cord to the left (toward the Y1-rail)
.
See
Figure 8‑4
.
3. Use the 4mm hex key to secure the compact
router by tightening the two (2) M5
×
55mm
socket head cap screws on the front of the
router mount as shown in
Figure 8‑4
.
Figure 8-2
Figure 8-3
Figure 8-4
Step 8
Compact Router