42
docs.carbide3d.com
43
Connect the Y-Axis Cables
1. Plug the Y1- and Y2-motor cables into the
corresponding connectors on the Carbide
Motion board labeled “Y1” and “Y2.” See
Figure 7‑11
.
2. Plug the Y-Axis proximity switch cable into the
corresponding connector labeled “Y” on the
PCB riser board. See
Figure 7‑11
.
Secure and Connect the X‑ and
Z‑Axis Cables
Secure the X- and Z-Axis Cables
1.
If you have not already done so, unravel all of
the cables at the back of the Z-Plus.
2. Gather the four X/Z-cables: the black Z-motor
lead, the X-motor lead, the Z-Axis proximity
switch cable and the X-Axis proximity switch
cable and secure them together with a cable
tie just above the X-motor. See
Figure 7‑12
.
3.
Use three (3) more cable ties, spaced
about 4.5 inches apart, to keep the cables
bundled together neatly in a long rope. See
Figure 7‑13
.
Connect the X- and Z- Cables
1. Plug the X- and Z-motor cables into the
corresponding connectors on the Carbide
Motion board labeled “X” and “Z.” See
Figure 7‑14
.
2. Plug the X- and Z-Axis proximity switch cables
into the corresponding connectors labeled
“X” and “Z” on the PCB riser board. See
Figure 7‑14
.
3.
Direct all cables through the cutout at the
bottom of the enclosure and re-install the
enclosure cover. Use the 2mm hex key on
the flanged button head cap screw. See
Figure 7‑15
.
4.
Use a pair of flush cut pliers or scissors to trim
the ends of all cable ties.
Apply the Shapeoko Build
Plate
1. Write your name on the Shapeko Build with
the included permanent marker and apply it to
the inside of the Y1-rail. See
Figure 7‑16
.
Figure 7-15
Figure 7-16
Figure 7-14
Figure 7-12
Figure 7-11
Figure 7-13
