SETTING DISPLAY - PAGE 2
(4)
INCORRECT POSITIONING OF WOOD
• This figure shows the wood moving distance is insufficient. In this
case, the wood positions on the pusher. This causes the pusher can't
touch the tail end of wood.
• When this problem occurs, you need to make length compensation.
• Use a steel rule to measure the distance from the tail end of wood to
the notch line.
• For example, if the distance measured is 50 mm, then you should
input a "+50"(mm) value in the "Length Comp.
mm".
puSHEr uNdEr WOOd
(NOT SHOWN)
WOOd
STEEL ruLE
NOTCH LINE
dISTANCE TO BE
COMpENSTATEd
INCPRRECT
POSITIONING
OF WOOD
WOOd pOSITIONS ON puSHEr
WOOd
puSHEr
EM-10 / EM-12
This manual describes the machine in current produce on.
We reserve the right to change the specifications without notice.
41
