B.MATERIAL THICKNESS ADJUSTMENT
The vertical/roller plate is mounted on two cylinders, refer to Fig. 4, which allows for the plate to be
lifted up if a splinter, bowed board, or something else has jammed up the machine. If a jam occurs, stop
the feed rollers and put the machine into manual mode. While in manual mode press the Lift button,
refer to Fig. 5 and also the “Touchscreen Manual”. The button will toggle between displaying Up or
Down, depending on the position of the vertical plate.
When changing thicknesses the Thickness guides can be used to assist with setting the Feed Roller
height. Raise the vertical plate using the Lift button on the touchscreen then place a piece of o
ff
cut
under the Thickness Guides, refer to Fig. 6. With the o
ff
cut under both ends, lower the vertical plate
down so the stops are resting on the Thickness guides. Now adjust the jacking bolts on the lift cylinders.
Remove the pieces of o
ff
cut board. Ensure both ends of the machine are set correctly.
THE HEIGHT OF THE ROLLERS MUST BE SET CORRECTLY, ON BOTH SIDES OF
THE MACHINE, FOR
EVERY
JOB, OTHERWISE PERMANENT DAMAGE MAY BE
CAUSED TO THE FEED SYSTEM.
EM-10 / EM-12
This manual describes the machine in current produce on.
We reserve the right to change the specifications without notice.
8
