Canon XJ22 7.3B Series, Operator'S Manual

Page: 166 / 326

E4-14
4. Menu screen – User
User – Copying data between lenses
(3) When an error display has appeared
If the settings were not copied successfully between the lenses, refer to the information in the table below.
Lens Connect
Error!!
Copy Error!!
Error screen Checkpoint Cause of error Remedial action
Has the dedicated
cable (20P-20P) been
connected?
Data cannot be copied between the
lenses unless the dedicated cable
(20P-20P) has been connected.
Securely connect the dedicated cable
(20P-20P) to the copy source lens and
copy destination lens, and go through
the copying procedure again from the
start.
Has the power of the
copy destination lens
been turned on?
Data cannot be copied between the
lenses unless the power of both the
copy source lens and copy destination
lens has been turned on.
Turn on the power of both the copy
source lens and copy destination lens,
and go through the copying procedure
again from the start.
Has the dedicated
cable (20P-20P) been
connected?
Have the power of both
the copy source lens
and copy destination
lens been turned on?
If, during copying, the cable
was disconnected or the power
of the copy destination lens
dropped or it was turned off, the
screen with the message shown
on the left will be displayed.
In a case like this, data copying has
been stopped before it was completed
and, as a result, the data is not copied
properly.
Check that the power of both the copy
source lens and copy destination
lens have been turned on and the
dedicated cable has been connected
securely. Then push the DISPLAY
sw and the display is switched to the
Screen A, and go through the copying
procedure again from the start.
User
Copy
ToOtherLens
1
Access: Unlock
Screen A