6251-006 Rev. 2
-
4 / 6 -
•
Bug corrections
No.
Item
Description
1
Correcting the weekly
timer function
In previous versions, the weekly timer function fails on the ID Input screen
used to make ID mode settings. The contributing factor for the problem
has been removed.
2
Correcting the cover mode
function
In previous versions, the machine picks up paper from a cassette not
containing the cover pages, stops the paper at the registration roller, and
resets itself under the following sequential conditions:
Cover mode is selected.
The selected cassette runs out of cover pages.
The selected cassette is replenished with cover pages.
The Copy start key is pressed.
3
Correcting RDF
malfunction
Previous versions fail to deliver an original remaining on the copyboard
glass to the RDF tray if a jam occurs during the delivery of the last copy to
the sorter.
4
Correcting image faults
Image faults (dirty image) occur on images on the backs of copies made on
paper larger than the originals in "two-sided original to two-sided copy"
and "punched hole erase" modes.
5
Correcting problem
encountered in use of ID
number
In the situation of using the copier machine with the Copy Data Controller-
A1 with its own power supply independent from the one for the copier, the
Controller retains the ID number inputted previously even after the power
for the machine main body is cut off. When the machine main body is
turned on again, a new ID number is not accepted since the Copy Data
Controller-A1 determines that an ID number acceptance has been already
made. This problem has been corrected.
6
Correcting a message
The jam icon appearing in front of the message "Insert Control Card" has
been removed.
7
Correcting a bug
If the Start key is pressed for a single original in "from one-sided original to
two-sided copy" mode using the RDF, the machine indicates the message
"Place Two or More Originals," and stops while issuing an alarm.
In response, if the Reset key is pressed or the original is removed and then
placed and the number of copies requested is changed, the motor will start
and continue to rotate for 50 sec without copying when the Start key is
pressed.
The software has been revised to correct the problem.
8
Correcting the message
display mechanism
Previous versions indicate the message "Remove Paper from Feeder" in
response to suspension of operation caused by an overstacking condition in
"feeder manual feed +non-sort stack" mode.
Since no paper is actually delivered to the feeder, the software is revised to
prevent the indication of this message. (The message, however, will be
indicated if the feeder is opened and then closed after suspension of
operation caused by an overstacking condition.)
9
Correcting the machine
stoppage mechanism
In case of a machine stoppage because of the absence of toner in "feeder
manual" mode, previous versions indicate the message "Press Start Key"
when the machine is replenished with toner. But the key pressing operation
is disabled because the original has been delivered. And the machine does
not initiate auto-start even when an original is set in the feeder manual feed
slot. This problem of inhibiting the continuation of the ongoing job has
been corrected.
