70
Problem:
– Solutions
No power
– Plug the power cord of the projector into the AC outlet.
– See if the POWER indicator lights red.
– Wait until the POWER indicator stops blinking to turn on the
projector again. The projector can be turned on after the
POWER indicator turns red. See page 1.
– Check the WARNING indicator. If the WARNING indicator lights
red, projector cannot be turned on. See page 70.
– Check the projection lamp. See page 68.
– Unlock the Key lock function for the projector. See page 60.
The initial display is not shown.
– Make sure
Off
or
Countdown off
are not chosen at display
function. See page 53.
The initial display is not same
– Make sure
User
or
Off
are not chosen at Logo (select)
as the default set.
function. See page 53.
Input signal switches automatically.
– Make sure Auto input function is adjusted properly.
(or does not switch automatically)
See page 5.
When the projector is on and
– That is the Filter warning icon. See page 60.
you press the input source
buttons, an icon other than
the Lamp mode icon appears
.
An icon other than Input mode
– That is the Lamp replacement icon or the Filter warning icon.
or Lamp mode icon appears.
See page 68 or 60.
Image is out of focus.
– Adjust focus of the projector. See page 6.
– Provide proper distance between the projector and the
projection screen. See page 15.
– Check the projection lens to see if it needs cleaning.
See page 67.
– Moving the projector from a cool to warm place may result in
moisture condensation on the projection lens. In such cases,
leave the projector off and wait until condensation evaporates.
Image is Left/Right reversed.
– Check the Ceiling/Rear function. See pages 38,40,48,50.
Image is Top/Bottom reversed.
– Check the Ceiling function. See pages 38,40,48,50.
Picture is not bright enough.
– Check if the
Contrast
or
Brightness
is adjusted properly.
See pages 36, 45.
– Check if
Image mode
is selected properly. See pages 35,44.
– Check the Lamp mode function. See pages 8, 59.
– Check the LAMP REPLACE indicator. If it lights, the end of lamp
life is approaching. Replace the lamp with a new one promptly.
See page 68.
Before calling your dealer or service center for assistance, check the items below once again.
– Make sure you have properly connected the projector to peripheral equipment as described on
pages 17-19.
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When the projector does not project an image from the connected computer, restart the computer.
Appendix
Troubleshooting
