Canon LaserBase MF8180C, Service Manual

Page: 107 / 296

Chapter 3
3-17
F-3-97
3.2.9.8 Removing the Right Frame
0011-6588
1) Remove the 5 screws [1], and detach the right frame [2].
F-3-98
3.2.9.9 Removing the Inside Cover
0008-9015
1) Remove the 2 claws [1], and detach the inside cover [2].
F-3-99
3.2.9.10 Removing the Shield Plate
0011-6610
1) Free the flat cable [1] from the connector.
2) Remove the 6 screws [2], and detach the shielding plate [3].
F-3-100
3.2.9.11 Removing the Registration Clutch
0007-8828
1) Disconnect the connector [1], and open the harness band [2].
2) Remove the E-ring [3], and detach the registration clutch [4].
F-3-101
The connector on the registration clutch side is designed to prevent discon-
nection. If you have to detach the registration clutch, be sure to disconnect
the connector (J113) on the DC controller PCB side.
3.2.9.12 Removing the Main Drive Assembly
0007-8831
1) Shift down the drive release lever [1], and remove the gear [2].
F-3-102
2) Remove the 2 screws [1], and detach the front sub cover [2].
F-3-103
When mounting the main drive assembly, be sure to fit the gear [2] as shown
with the drive release lever [1] in down position (i.e., with drive engaged).
At this time, be sure that the position of the gear is correct so that it is fully
engaged with the gear of the drive release lever.
F-3-104
[1]
[2]
[1]
[1] [2]
[1]
[2]
[2]
[2]
[3]
[1]
[1] [2] [3] [4]
[1]
[2]
[1] [2]
[1]
[2]