Canon LaserBase MF8180C, Service Manual

Page: 247 / 296

Chapter 3
3-157
F-3-1016
12) Remove the cable [1] from the guide [2].
13) Remove the 2 claws [4], and disconnect the connector [3].
14) Free the cable from the edge saddle [5].
F-3-1017
15) Remove the 1 screw [1] and slide the fixing separation guide [2] out to
the left.
F-3-1018
Make sure that all cables on the fixing film unit are hooked into the fixing
separation guide when reassembling the guide. Especially the right-side ca-
bles are easy to be pinched unless properly
hooked into the guide.
F-3-1019
16) Lift the fixing film unit [1] up straight in horizontal position to take it out
of the fixing unit.
F-3-1020
3.7.3 Fixing Pressure Roller
3.7.3.1 Removing the Fixing Assembly
0011-7853
1) Turn the lever [1] of the fixing assembly 90 deg in the direction of the
arrow.
2) While holding the grip [2], slide out the fixing assembly [3] toward the
front and out of the machine.
Whenever you have to replace the fixing assembly, be sure to disconnect the
power cord first. Also, be sure to wait unit the fixing assembly has cooled
before removing it after disconnecting the power cord.
F-3-1021
3.7.3.2 Removing the Face-Up Cover
0011-7854
1) Turn the fixing lever [1] of the fixing assembly 90 deg in the direction of
the arrow.
2) Remove the 4 claws [2], and detach the face-up cover [3] from the fixing
assembly.
F-3-1022
3.7.3.3 Removing the Fixing Film Unit
0011-7855
1) Unhook the 1 claw [1] and remove the pressure roller gear[2].
2) Unhook the 1 claw [3] and remove the delivery roller gear[4].
3) Remove the idle gear[5].
[1]
[3]
[2]
[4]
[1]
[2]
[2]
[4]
[3]
[3]
[5]
[1]
[2]
[1]
[2]
[1]
[1] [1] [3] [2]
[1] [1]
[2]
[3]