Canon LaserBase MF8180C, Service Manual

Page: 147 / 296

Chapter 3
3-57
3.3.4.6 Removing the operation Panel
0007-8099
1) Remove the 2 screws [1], and free the 2 claws [2] (left/right) to open the
operation panel [3].
F-3-368
2) Disconnect the 2 flat cables [1], and remove the 2 fastons [2]; then, detach
the operation panel [3].
F-3-369
3.3.4.7 Removing the Scanner Cover Unit
0007-8101
1) Remove the copyboard cover.
2) Remove the 2 screws [1].
3) Remove the 6 claws [2], and detach the scanner cover unit [3].
F-3-370
3.3.4.8 Removing the Flat Bed Motor Unit
0008-9018
1) Remove the screw [1], and detach the plate [2].
2) Remove the 2 screws [3], and detach the flat bed motor unit [5] while
paying attention to the drive belt [4] of the CCD unit.
F-3-371
3.3.4.9 Removing the CCD Unit
0007-8104
1) Push the claw [1], and free the core [3] and the flat cable [4] from the claw
[2]; then, disconnect the connector [5].
2) Pull out the flat cable [4] from the core [3] and the flat cable retainer [6]
by pulling it in the direction of the arrow.
3) Lift the shaft [7] to detach it from the groove; then, detach the CCD unit
[8].
F-3-372
3.3.5 Separation Guide Unit
3.3.5.1 Removing the Rear Cover
0009-9017
1) Disconnect the cable [1] of the power supply assembly.
2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.
[1]
[2]
[2]
[3]
[1] [2] [2]
[3]
[1]
[2]
[2]
[3]
[2]
[1] [2]
[4] [3] [5] [3]
[8]
[7]
[5]
[3]
[4]
[1]
[6]
[4] [2]
[3]