Canon iR2318 series, Service Manual, Page: 83 / 308

Chapter 2
2-29
13) Pass the heater harness [1] though the harness guide [2] with the clamp
[3] of the heater harness aligned with the notch [4] in the harness guide.
F-2-70
14) Secure the harness guide [1] to the rear bottom of the reader together with
the heater harness [2].
15) Connect the heater connector (right) [3] to the hole [4] of the frame of
the reader unit.
16) Install the wire saddle [5], and then pass the heater harness [2] through it.
17) Connect the heater connector (left) [5] to the hole [7] of the frame of the
reader unit.
18) Install the four wire saddles [8], and then pass the heater cable through
them.
19) Connect the heater harness [2] to the connector (J1904) [10] on the heater
PCB.
F-2-71
20) Install the reader flexible cable cover at the original position, and then
perform steps 9 to 11 in reverse to connect the reader flexible cable to the
image processor PCB.
Don't mistake the notch [4] and the notch [5] for screw stop.
[5]
[3]
[4]
[1] [2]
MEMO:
Rout the heater cable so as its terminal [9] to be connected at the position
shown in the Figure.
[7]
[5]
[8] [10]
[3]
[1] [2] [6] [9]
[4]