Canon imagePROGRAF PRO-6600, Online Manual

Page: 95 / 939

Note
• If you selected Do not cut , the roll paper will not be cut after printing regardless of the •
Cutting mode setting on the printer. Select this option when you want to print multiple pages
consecutively without cutting.
• If you selected Use the cutting mode setting , cutting for each page will be performed •
according to the Cutting mode setting on the printer.
Specifying the Cutting Method for Rolls
• If you select Use the cutting mode setting , and Automatic cut is set in the Cutting mode •
settings on the printer, we recommend setting Wind up after cutting to Enable . When set to
Disable , a printed document that has been taken up is cut automatically without being pressed,
resulting in fraying.
• If roll paper is loaded from the roll unit to the printer, a screen confirming whether or not to •
remove the roll paper appears. If you select Yes , the roll paper is positioned so that it can be
removed and the roll unit changes to a take-up device.
6. Check the contents of the message and select Yes or No . 6.
If you select Yes , the steps for loading the paper on the roll unit appear on the touch
screen.
If you select No , the operation ends here. Load the paper on the roll unit when
printing. However, in this case, you must load the paper while printing is progressing,
so instructions will not appear on the touch screen.
For details on loading paper on the roll unit set as a take-up device, see " Using the Roll
Unit In Take-Up Mode ."
Note
• If you select Yes , a margin of approximately 23.7 inches (600 mm) is generated at the leading •
edge because the roll paper advances to the roll unit before printing.
Using as feed device
1. Select the paper setting display area on Home screen. 1.
95