1
1
1-16
1-16
Initial Setup > Basic Operation > Replacement/Cleaning Mode > Terminating Replacement/Cleaning Mode
Initial Setup > Basic Operation > Replacement/Cleaning Mode > Terminating Replacement/Cleaning Mode
■
Terminating Replacement/Cleaning Mode
After the replacement or cleaning of the target parts is finished, clear the counters, exit
Replacement/Cleaning mode, and then return to Operator Maintenance mode.
(For clear the counter, refer to "Clearing the Counter"(page 1-12).)
1) Press [End Rplcmt./Cleaning] on replacement/cleaning mode screen in Operator
Maintenance mode.
-> The message will be shown on the screen to confirm Replacement/Cleaning mode
termination.
2) Press [Yes].
F-1-32
F-1-33
-> Close Replacement/Cleaning mode to return to Operator Maintenance mode. Then
the operator maintenance basic screen is shown.
