Canon FAX-L350, Service Manual

Page: 149 / 213

3-38
FAX-L350 Chapter 3: Maintenance and Service
5.2.5 New SSSWs/parameters added to this model
#1 SSSW (service soft switch setting)
SW01 (service soft switch 01: error management)
Bit
Function 1 0
0 Service error code Output Not output
1 Error dump list Output Not output
2 Not used
3 Copy function No Yes
4 (New) ##300 series service error code Output Not output
5 Not used
6 Data & Time setting restriction Setting possible Setting restricted
7 User setting restriction Setting possible Setting restricted
[Bit 4]
Even when Bit0 is set to “ NOT OUTPUT ”, you can select whether or not to output ##300 series
Service Error Codes, caused by hardware malfunction.
When “
OUTPUT ” is selected, ##300 series Service Error Codes are displayed and included in reports.
When “ NOT OUTPUT ” is selected, no Service Error Codes are displayed.
#1 SSSW (service soft switch setting)
SW05 (service soft switch 05: standard function <DIS signal> settings)
Bit
Function 1 0
0 Not used
1 Not used
2 Not used
3 Send DIS signal bits 33 and over No Yes
4 Recording paper length availability A4 size Abiitrary size
deciared in DIS signal
5 (New) Declare LTR/LGL in DIS signal No Yes
6 Not used
7 Not used
[Bit 5]
Select whether to declare LTR or LGL in DIS signal when the LTR or LGL recording paper is used.
The recording paper is selected according to the setting of #7 printer SW04 bit 0.
#1 SSSW (service soft switch setting)
SW15 (service soft switch 15: Dial inn FAX/TEL switching function setting)
Bit
Function 1 0
0 Not used
1 Not used
2 Not used
3 Not used
4 Not used
5 Not used
6 (New) Detect continuous signal at Yes No
FAX/TEL switching
7 Not used
[Bit 6]
You may enable or disable detection of ROT continuous signal for FAX/TEL switching.
Normally, only ROT intermittent signals are detected for FAX/TEL switching. If you need to detect
both in view of exchange specifications,select “1” to enable detection.