Canon DADF-R1, Service Manual

Page: 209 / 222

Chapter 6
6-5
0075 image lead edge fault S7 In stream reading, no change of read position has taken place despite a request
for a change of reading position.
0076 1st sheet image lead
edge position fault S7 An image lead edge fault condition (0075) has occurred on the 1st sheet.
0077 belt speed setting fault PI1 The speed setting of the belt motor is the minimum speed (100 mm/sec) or
lower or is the maximum speed (700 mm/sec) or higher.
0078 belt speed switchover
fault PI1 At time of a belt motor speed switchover, the belt motor is not operating at a
specific speed.
0079 belt status fault PI1 At time of a switchover of the belt motor state (acceleration, constant,
deceleration), the motor is not in any of the 3 states.
0080 image lead edge
output timing
fault S2, S3,
SW301 At time of stream reading, the image lead edge signal is generated during
acceleration over the distance from standby position to image lead edge
position.
0081 reversal speed setting
fault PI5 The speed setting of the reversal motor is the minimum speed (100 mm/sec)
or lower or is the maximum speed (700 mm/sec) or higher.
0082 reversal speed
switchover fault PI5 At time of a reversal motor speed switchover, the motor is not operating at a
specific speed.
0083 reversal status fault PI5 At time of a switchover of the motor state (acceleration, constant,
deceleration), the motor is not in any of the 3 settings.
0084 last original error PI1 While the last original is being discharged from the platen roller or is being
moved, a belt motor error has occurred.
0085 error PI1, PI2,
PI11 A motor error other than an IPC communication/pickup error has occurred.
(less than 3 occurrences)
0090 ADF open PI10 An ADF open condition has been detected.
0091 user DF open PI10 An ADF open condition has been detected while the machine is in operation.
0092 cover open PI3, PI6 A cover open condition (front or rear) has been detected.
0093 user cover open PI3, PI6 While the machine is operating, a sensor in the paper path has detected an
original.
0094 initial stationary PI4, PI12,
PI13, S1,
S2, S3,
S4, S5,
S9 At the start of operation, the presence of an original has been detected by a
senser in the paper path.
0095 cycle NG S6 While no sensor is on, the pickup signal is received for a specific time (2 sec).
0096 residual original S1 Before the start of a left pickup job, the reversal sensor has detected an original
while the belt motor is being driven for a specific time.
0097 manual feeder
residual original S1, S9 At time of manual feed pickup, the reversal sensor detects an original while
the manual feeder registration roller sensor also detects an original.
0098 power-down - While the machine is operating, a drop has occurred in the voltage of the
power supplied by the host machine.
Code Sensor type Sensor
notation Description