Canon DADF-R1, Service Manual

Page: 116 / 222

Chapter 3
3-58
3.7.2 List of Jam Code
0013-3520
The following shows jam codes, jam types, and associated sensors with descriptions of detection conditions:
T-3-13
Code Sensor type Sensor
notation Description
0001 separation delay S4 At time of separation, the separation sensor does not detect the
original when it has been moved over a specific distance (221 mm)
after the start of the separation motor.
0002 pickup delay S4, S2 At time of separation, the pre-registration sensor does not detect the
original when it has been moved over a specific distance (93 mm)
after the separation sensor has detected its lead edge.
0003 pickup stationary 1 S3 At time of pickup, the post-registration sensor does not detect the
original when it has been moved over a specific distance (40 mm)
after the start of the reversal motor.
0004 pickup stationary 2 S2 At time of pickup, the pre-registration roller sensor detects the
original when it has been moved over a specific distance (330 mm if
small; 660 mm if large) after the start of the reversal motor.
0005 reversal delay S1 At time of reversal, the reversal sensor does not detect the original
when it has been moved a specific distance (104 mm) from the platen
roller.
0006 reversal stationary S1 At time of reversal, the reversal sensor detects the original when it has
been moved over a specific distance (original length x 1.5 mm) after
the end of arching.
0007 delivery delay PI13 At time of delivery, the delivery sensor does not detect the original
when it has been moved over a specific distance (631 mm - original
length) after the start of the belt motor.
0008 delivery stationary 1 PI13, S9 At time of delivery, the manual feeder registration roller sensor
detects the original when it has been moved over a specific distance
(original 100 mm) after the delivery sensor has gone on.
0009 delivery stationary 2 PI13, S9 At time of delivery, the delivery sensor detects the original when it
has been moved over a specific distance (100 mm) after the manual
feeder registration roller sensor has gone off.
0010 pre-reversal delay 1 S3 At time of pre-reversal, the post-registration roller sensor does not
detect the original after it has been moved over a specific distance (50
mm) from the start of the reversal motor.
0011 pre-reversal delay 2 S1, S3 At time of pre-reversal, the reversal sensor does not detect the
original when it has been moved over a specific distance (100 mm)
after the post-registration roller sensor has gone on.
0012 pre-reversal delay 2 PI4 At time of pre-reversal, the pre-reversal sensor does not detect an
original when the reversal motor stops.
0013 pre-reversal stationary 1 S1, S4 At time of pre-reversal, the separation sensor detects the original
when it has been moved over a specific distance (169 mm) after the
reversal sensor has gone on.
0014 pre-reversal stationary 2 S2, S4 At time of pre-reversal, the pre-registration roller sensor detects the
original when it has been moved over a specific distance (120 mm)
after its trail edge has moved past the separation pull-off roller.
0015 pre-reversal stationary 3 S2, S3 At time of reversal, the post-registration sensor detects the original
when it has been moved over a specific distance (50 mm) after its trail
edge has moved past the pre-registration roller sensor.
0016 pre-reversal stationary 4 S1, S3 At time of pre-reversal, the reversal sensor detects the original when
it has been moved over a specific distance (100 mm) after the start of
the reversal motor.