Canon Color imageRUNNER C3380 Series, Reference Manual

Page: 149 / 550

Finisher-Z1 3-21
3
Optional Equipment
CAUTION
Do not place your hand in the part of the tray where stapling is performed if a
finisher is attached, as this may result in personal injury.
IMPORTANT
•
If the Staple mode is set, the output tray moves downward as the stack of paper that is
output increases in quantity and thickness. Once the output tray has reached its stacking
limit, or after 30 sets of prints have been output, printing and stapling stop temporarily.
Remove all of the stapled prints from the output tray, and printing and stapling resume.
•
Only the following paper sizes can be stapled: 11" x 17", LGL, LTR, or LTRR.
•
You cannot staple envelopes, transparencies, coated paper, tracing paper, or labels.
•
Do not pull copies or prints out of the output area while they are being stapled. Remove
the copies or prints after they are output to one of the output trays.
NOTE
•
The maximum number of sheets, including cover sheets, that can be stapled together is
as follows (Only 17 to 28 lb bond (64 to 105 g/m
2 ) paper can be used for the main
document, and 17 lb bond to 90 lb index (64 to 163 g/m 2 ) paper can be used for the cover
page):
- LTR
50 sheets (17 to 20 lb bond (64 to 80 g/m 2 ))
30 sheets (20 to 28 lb bond (81 to 105 g/m 2 ))
2 sheets (28 lb bond to 90 lb index (106 to 163 g/m 2 ))
- 11" x 17", LGL, LTRR
30 sheets (17 to 20 lb bond (64 to 80 g/m 2 ))
20 sheets (20 to 28 lb bond (81 to 105 g/m 2 ))
2 sheets (28 lb bond to 90 lb index (106 to 163 g/m 2 ))
•
If the machine stops while stapling and the message <Load staples.> appears, almost all
of the staples have been used, and the staple cartridge must be replaced. To proceed,
replace the staple cartridge. (See "Replacing the Staple Cartridge," on p. 7-29.)