Canon AX-C4343W, Technical Document

Page: 37 / 86

4
Operating procedures
37
2
Register the detector and make connection to the control
system.
Press and release the POWER switch
again.
READY LED lamp flashes
(approx. 3 seconds).
While READY LED lamp flashes
(approx. 3 seconds), locate the IR
data port of the detector near the
ready indicator or the IR data
communication unit (within 30 cm).
When the registration is completed, the
two LED lamps on the ready indicator
flash three times for 0.5 seconds at 0.5
second intervals, and a three-tone beep
is emitted.
Proceed to the next
Connection
.
Communication link is automatically
established between the internal
wireless module of the detector and
the wireless access point/control
system.
Registration
Once the registration is completed, it is not required for every use unless the
user changes the use environment. Conversely, the registration is required if the
detector having been used in another environment is moved back to the
previous environment.
After moving the detector to another use environment while the power is on, turn
off the detector and turn it on again before establishing the communication link.
Information
Important
Connection
000_DIA-2019-019-E03_AX-C4343W.book Page 37 Friday, November 27, 2020 12:38 PM