Canon AX-C4343W, Technical Document

Page: 29 / 86

3
Parts names and functions
29
This box connects and relays control signals between the X-ray generator, the image-
capture computer, the Docking Station and other equipment. The battery pack attached
to the detector is also charged while the wiring cable (sold separately, optional) is
connected to the detector (charging time: approx. 120 minutes).
This unit synchronizes the timing of X-ray irradiation with the detector’s capture. No
operation is required for this unit while using the system.
* Required specifications for a cable connected at installation by a service engineer are as follows:
• The X-ray interface cable must be connected to the secondary circuit of an X-ray generator that is
compliant with IEC 60601-1, and that circuit must be isolated from commercial power.
The input/output values for the X-ray generator’s communication circuit must not fall outside the
specification range as indicated below:
Signal input part (SIP): Max. voltage: 5 V DC
Signal output part (SOP): Max. voltage: 250 V AC/30 V DC
Current range: 10 mA to 2 A
• The X-ray interface box and X-ray generator must be grounded to a common protective earth.
3.2 Multi Box
3.3 X-ray interface unit
A Ground terminal Accepts the ground.
B X-ray interface cable Connects* to the X-ray generator.
C LAN cable connector Accepts the LAN cable.
D DC IN jack Accepts the power cord of the dedicated AC
adapter.
E POWER lamp Indicates the power status of the X-ray interface box.
B C D E A
000_DIA-2019-019-E03_AX-C4343W.book Page 29 Friday, November 27, 2020 12:38 PM