Subsection XX (MAGNETO AND STARTER)
PROCEDURES
MAGNETO COVER
Magneto Cover Access
Refer to the
BODY
subsection and remove the fol-
lowing part.
vmr2016-403-001
ENGINE WITH 420W MAGNETO
vmr2016-403-002
ENGINE WITH 650W MAGNETO
Removing the Magneto Cover
Drain engine oil (refer to
ENGINE OIL CHANGE
in the
PERIODIC MAINTENANCE PROCEDURES
subsection).
Remove crankshaft position sensor (CPS) and cut
tie raps.
Disconnect the stator connector on the voltage
regulator/rectifier, refer to
STATOR CONNECTOR
ACCESS
in this subsection.
Remove dipstick with O-ring.
vmr2015-030-002_a
1. Dipstick
2. O-ring
3. Crank position sensor (CPS)
Remove magneto cover retaining screws.
vmr2015-030-003_a
1. Magneto cover
2. Retaining screws
Pull out magneto cover.
Inspecting and Cleaning the Magneto
Cover
Check magneto cover for cracks or other damage.
Replace if necessary.
NOTE:
Clean all metal components in a non-
ferrous metal cleaner. Use
LOCTITE CHISEL (GAS-
KET REMOVER) (P/N 413 708 500)
, or suitable
equivalent.
WARNING
Wear safety glasses and work in a well
ventilated area when working with strong
chemical
products.
Also
wear
suitable
non-absorbent gloves to protect your hands.
vmr2016-403
3
