Subsection 11 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT)(570/850))
vmr2006-021-035_a
1. Retaining ring
2. Torque gear
3. Fixed sheave of driven pulley
NOTE:
The following procedure is not necessary
except if ball bearing or shaft must be removed.
Refer to
INSPECTION
before proceeding.
2. Heat ball bearing area up to 100°C (212°F) be-
fore removing ball bearing.
tmr2011-015-009_a
1. Ball bearing
2. Shaft
3. Fixed sheave of driven pulley
3. Use a soft hammer to push shaft and bearing
out of fixed sheave.
2
R610tran18A
1
1. Soft hammer
2. Shaft
4. Remove shaft from ball bearing.
5. Remove distance sleeve and O-ring from coun-
tershaft.
6. Replace O-ring if brittle, hard or damaged.
vmr2006-021-044_b
1. O-ring
2. Distance sleeve
Cleaning the Driven Pulley
When a dust deposit has to be removed from the
cam or the shaft, use a dry cloth.
Clean pulley faces and shaft using fine steel wool
and a dry cloth.
Clean driven pulley using the recommended prod-
uct.
RECOMMENDED PRODUCT
PULLEY FLANGE CLEANER (P/N 413 711 809)
Clean the CVT air guide area from contamination.
vmr2016-404
15
