Can-Am 219 002 095, Operator'S Manual

Page: 127 / 196

MAINTENANCE PROCEDURES
vmr2007-051-006_a
1. Arrow printed on belt
2. Drive pulley (front)
3. Driven pulley (rear)
4. Rotation direction
Turn the driven pulley until the low-
est portion of the cogs on the external
surface of drive belt is even with the
driven pulley edge.
tmo2013-003-060_a
1. Lowest portion of cogs even with external
surface of drive belt
Drive and Driven Pulleys
Drive and Driven Pulleys Inspection
This inspection must be performed by
an authorized Can-Am dealer, repair
shop, or person of your own choosing
for maintenance, repair, or replace-
ment.
Drive Pulley
Inspect the bushings of the sliding
sheave of the drive pulley, replace
worn parts.
Driven Pulley
Inspect the bushings of the cam and of
the sliding sheave of the driven pulley,
replace worn parts.
Battery
CAUTION Never charge a bat-
tery while installed in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
NOTICE
Never remove the battery
sealing cap.
Battery Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
NOTICE
Always disconnect
BLACK (-) battery cable first.
Remove retaining screws, battery
holding strap then pull the battery out
of frame.
vmo2012-012-031_a
1. Battery holding strap
2. Retaining screws
Battery Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
______________
125