Can-Am 219 002 095, Operator'S Manual

Page: 118 / 196

MAINTENANCE PROCEDURES
tmo2011-001-502_a
TYPICAL
1. Rear cylinder bleed screw
2. Remove the pressure cap.
3. Fill the cooling system until coolant
comes out of the bleed screw(s).
4. Install the bleed screws using NEW
gasket rings and tighten to specifi-
cation.
TIGHTENING TORQUE
Bleed
screw
4.4 N•m to 5.6 N•m
(39 lbf• in to 50 lbf• in )
5. Add coolant until system is full up to
the pressure cap seat.
6. Start engine.
NOTE: Do not install pressure cap.
7. Run engine at idle until coolant fan
turns ON.
NOTE: Monitor coolant level during
engine warm-up and add coolant as re-
quired.
8. Depress the throttle lever two or
three times; check coolant level.
9. Stop the engine and let it cool down.
10. Inspect cooling system for leaks.
11. Check coolant level in the reser-
voir. Add coolant as required.
12. Install pressure cap.
Reinstall:
– Console
– Gauge support
– Seat.
Muffler Spark Arrester
Muffler Spark Arrester Cleaning and
Inspection
NOTE: Spark arrester screen replace-
ment is required only when damaged.
CAUTION Let exhaust system
cool down before proceeding with
cleaning and inspection.
Remove and discard the tail pipe retain-
ing screws.
vmo2012-012-709
TYPICAL - REMOVE TAIL PIPE
Remove exhaust tail pipe, gasket (dis-
card) and spark arrester.
vmo2012-014-014_a
TYPICAL
1. Gasket
2. Exhaust tail pipe
Remove carbon deposits from the
spark arrester using a brush.
116
______________