Can-Am 2018 Defender Series, Operator'S Manual

Page: 61 / 187

MULTIFUNCTION GAUGE (LCD)
Navigating in the LCD
Gauge
Default Display Mode
After vehicle startup, the default dis-
play mode is either:
– Vehicle speed
– Engine
revolutions per minute
(RPM)
– Both parameters simultaneously
(combined mode).
To change from one display to the
other, proceed as follows.
1. Turn key to ON to power-up the sys-
tem up.
2. Wait until the “greeting message”
has been displayed.
3. Press and release selector button
once to display OD (odometer).
4. Press the selector button again, this
time for 2 seconds.
This will change the Mode to either
Speed, RPM or Combined.
vdd2008-001-083
5. To select another mode, repeat
steps 3 and 4 until the desired mode
is displayed.
Temporary Display Mode
In the temporary display mode, the fol-
lowing functions are available:
– Odometer
– Clock
– Trip meter (resettable)
– Trip Hour meter (resettable)
– Engine hour meter.
Press and release selector button to
change the default display mode to the
temporary mode.
tmo2011-001-702_c
1. Selector button
The gauge will display the selected
mode for 10 seconds then will return
to the normal display mode.
While in a resettable mode, push and
HOLD selector button for 2 seconds to
reset it.
Gauge Setup
Clock Setting
Once clock display as been selected,
use the display selector button to set
clock as follows:
vmo2011-008-001_a
1. Selector button
2. Time
1. Press and HOLD button (Display will
flash).
2. Choose the 12-hour (12H) or
24-hour (24H) format by pressing
button.
_______________
59