Can-Am 2018 Defender Series, Operator'S Manual

Page: 113 / 187

MAINTENANCE PROCEDURES
219001807-005_a
1. Tailpipe
2. Gasket
3. Spark arrester
Remove carbon deposits from the
spark arrester using a brush.
NOTICE
Use a metallic soft brush
and be careful to avoid damaging
spark arrester mesh.
tmo2011-001-043_a
1. Clean spark arrester
Inspect mesh of spark arrester for any
damage. Replace as required.
Inspect spark arrester chamber in muf-
fler. Remove any debris as required.
Reinstall the muffler spark arrester in
the reverse of the removal procedure.
However pay attention to the follow-
ing.
Install new gasket and fasteners.
Tighten to specification.
TIGHTENING TORQUE
Tailpipe retaining
screw
32 N•m ± 2 N•m
(24 lbf•ft ± 1 lbf•ft)
Gearbox Oil (HD8 and
HD10)
Gearbox Oil Level Verification
Place the vehicle on a level surface.
Select PARK position.
Check the gearbox oil level by remov-
ing the gearbox oil dipstick.
tmo2016-010-169_a
1. Engine oil dipstick
2. Gearbox oil level plug
Remove dipstick again and check oil
level. It should be near or equal to the
upper mark.
tmr2016-106-005_a
1. MIN.
2. MAX.
3. Operating range
To add oil, place a funnel into the dip-
stick hole.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark.
______________
111