0.0.0.0. If DHCP is enabled, the default gateway obtained from the local DHCP server will be
displayed in the Status box on the Deployment > NL241 tab.
NOTE:
In bridge mode, this setting is obtained from the data logger and cannot be edited here. It
must be edited in the data logger settings. The setting obtained from the data logger will be
displayed in the Status box on the Deployment > NL241 tab.
B.1.12 DNS Servers
This setting specifies the addresses of up to three domain name servers that the device can use to
resolve domain names to IP addresses. Note that if DHCP is used to resolve IP information, DNS
addresses obtained via DHCP will override this list.
B.1.13 IP Info
Reports the IP address, network mask, and default gateway of the network interface. If DHCP is
used, this setting will report the values configured by the DHCP server.
B.1.14 Admin Password
To help guard against unauthorized access to the NL241, it is password-protected by the admin
password. This password will be required to gain access to the NL241 via
Device Configuration
Utility
over TCP and Telnet. If the password setting is left blank, no password is required to access
the NL241. After settings are saved, the new password will be in effect.
B.1.15 TCP Configuration Port Number
The default TCP port number for configuration via TCP is 6786. This entry makes it possible for
the user to change the port number used in TCP configuration. Typically, it is not necessary to
change this entry from its default (range 1 to 65535).
B.2 Wi-Fi tab
B.2.1 Wi-Fi Status
Status of the Wi-Fi Module.
B.2.2 Configuration
This setting controls whether the device is configured to join an existing network or create a
network.
NL241 Wireless Network Link Interface
48
