NOTE:
When Browse
is clicked or the Refresh button inside the resulting dialog is clicked, if the
device is currently connected to a network, the connection will be temporarily interrupted.
The device will disconnect, scan for available networks, then reconnect.
B.2.4 Password
If joining a WPA or WPA2 security enabled network, this is where the password is entered. If
joining a WEP security enabled network, this is where the WEP key is entered.
If creating a network and a password is supplied, the network will be created using WPA2
encryption. The password must be at least 8 characters. If a password is not supplied, an open
(unencrypted) network will be created.
When joining a network, the device supports 64-bit WEP and 128-bit WEP. For 64-bit WEP, enter
a 40-bit key in the form of 5 ASCII characters or 10 hexadecimal digits (0-9, A-F). For 128-bit WEP,
enter a 104-bit key in the form of 13 ASCII characters or 26 hexadecimal digits (0-9, A-F).
B.2.5 EAP User
If joining an Enterprise Security enabled network, enter the user name here.
B.2.6 EAP Password
If joining an Enterprise Security enabled network, enter the password here.
B.2.7 EAP Method
The EAP Method must be set to match the EAP method being used by the Enterprise Security
Network. The inner EAP Methods supported are MSCHAPv2, MSCHAP, CHAP, and PAP.
B.2.8 Button Configuration
This setting controls how the device acts when the Mode button is pressed.
Disable Button
If this configuration is selected, pressing the button will have no effect on the operation of the
device. The Wi-Fi network will continue to work as configured.
Temporarily Enable Wi-Fi
If this configuration is selected, the configured Wi-Fi network will normally be disabled and it
will be activated temporarily when the button is pressed.
NL241 Wireless Network Link Interface
50
