Campbell CR3000 Micrologger, Operator'S Manual

Page: 587 / 644

Appendix A. Info Tables and Settings
587
PakBusRoutes
String Y
•
Settings Editor: Advanced | Route Filters
•
Status
table field: ≈45
Lists routes or router neighbors known to the CR3000 at the time the setting was read. Each
route is represented by four components separated by commas and enclosed in parentheses:
(port, via neighbor adr, pakbus adr, response time).
Default =
(1, 4089, 4089, 1000).
Updates when routes are added or deleted.
PakBusTCP
Clients
String
•
Settings Editor: Network Services | PakBus/TCP Clients
Up to four addresses specifying outgoing PakBus/TCP connections for the CR3000 to
maintain.
PakBusTCP
Enabled
Numeric
•
Settings Editor: Datalogger | PakBus/TCP Password
Enables (True [default]) or disables (False) the PakBus TCP service.
PakBusTCP
Password
String
•
Settings Editor: Datalogger | PakBus/TCP Password
When active (not blank), a log-in process using an MD5 digest of a random number and this
password must take place successfully before PakBus communications can proceed over an
IP socket.
PanelTemp FLOAT Y
•
Station Status field: Panel Temperature
•
Status table field: 12
Current wiring-panel temperature (°C). Measurement is made in auto self-calibration. When
auto self-calibration executes (once per minute).
PingEnabled Numeric
•
Settings Editor: Network Services | Ping (ICMP) Enabled
Enables (True [default]) or disables (False) the ICMP ping service.
PortConfig()
String Y
•
Status
table field: ≈43
Sets up C terminals in numeric order of terminals. Set up for input, output, SDM, SDI-12,
COM port. Default =
Input. Updates when the port configuration changes.
PortStatus() Numeric
•
Status
table field: ≈42
States of C terminals configured for control. On/high (True) or off/low (False). Array
elements in numeric order of C
terminals. Default =
False. Updates when state changes.
pppDial String
•
Settings Editor: PPP | Modem Dial String
Specifies the dial string that follows ATD or a list of AT commands separated by ';' that are
used to initialize and dial through a modem before a PPP connection is attempted. A blank
string means that dialing is not necessary before a PPP connection is established. CRBasic
program will recompile if changed from NULL to not NULL, or from not NULL to NULL.
pppDialResponse
String
•
Settings Editor: PPP | Modem Dial Response
Specifies the response expected after dialing a modem before a PPP connection can be
established. Default is CONNECT. CRBasic program recompiles if changed from NULL to
not NULL, or from not NULL to NULL.
pppInfo String
•
Settings Editor: PPP | PPP Network Status