Page
26
- Manual
FA01798-EN
- 01/2023 - © C
AME S.p.A. - The contents of this manual may be changed at any time and without notice. - T
ranslation of the o
riginal instructions
Adjusting the partial opening
Set the gate’s partial-opening percentage.
Configuration >
Gate travel settings
Part. open point
10% to 100% (Default 100%)
Opening slowdown point
Set the percentage of the total travel to be used for slowdown during gate opening.
During travel calibration, the opening slowdown point is automatically set to allow for a slowing space of 60 cm.
Configuration >
Gate travel settings
Opening slowdown point
Deactivated (Default)
1% to 50%
Closing slowdown point
Set the percentage of the total travel to be used for slowdown during gate closing.
During travel calibration, the closing slowdown point is automatically set to allow for a slowing space of 60 cm.
Configuration >
Gate travel settings
Closing slowdown point
Deactivated (Default)
1% to 50%
Opening slowdown speed
Set the slowdown speed during opening (as a percentage of the maximum speed).
The parameter is only used with the [Opening slowdown point] function active.
If the slowdown speed is incorrectly set to a value higher than the opening speed by mistake, the parameter is corrected.
Configuration >
Gate travel settings
Opening slowdown speed
1% to 50% (Default 40%)
Closing slowdown speed
Set the slowdown speed during closing (as a percentage of the maximum speed).
The parameter is only used with the [Closing slowdown point] function active.
If the slowdown speed is incorrectly set to a value higher than the closing speed by mistake, the parameter is corrected.
Configuration >
Gate travel settings
Closing slowdown speed
1% to 50% (Default 40%)
Slowdown AST control
Adjust the obstruction detection sensitivity during slowdown in percentage terms.
The parameter is only used if the opening or closing slowdown point is active.
Configuration >
Gate travel settings
Slowdown AST control
Deactivated (Default)
Maximum thrust and low obstruction sensitivity.
Minimum
Average
Maximum*
*
Minimum thrust and high obstruction sensitivity.
Customised
The personalised values to be used are expressed as a percentage:
- from 10% (minimum thrust and high obstruction sensitivity)
- to 100% (maximum thrust and low obstruction sensitivity)