Chapter 5: Installation
Installing the copper Cat5e Ethernet interface
Page
21
Installing the copper Cat5e Ethernet interface
To install the copper Cat5e Ethernet interface, use the following procedures:
•
•
Install the bottom LPU to PSU drop cable
•
Installing external antennas to a connectorized ODU
Caution
To avoid damage to the installation, do not connect or disconnect the drop cable
when power is applied to the PSU or network terminating equipment.
Caution
Always use Cat5e cable that is gel-filled and shielded with copper-plated steel.
Alternative types of Cat5e cable are not supported by Cambium Networks.
Cambium Networks supply this cable (Cambium part numbers WB3175 and
WB3176), RJ45 connectors (Cambium part number WB3177) and a crimp tool
(Cambium part number WB3211). The LPU and grounding kit contains a 600-mm
length of this cable.
Install the main drop cable
Warning
The metal screen of the drop cable is very sharp and may cause personal injury.
•
ALWAYS wear cut-resistant gloves (check the label to ensure they are cut resistant).
•
ALWAYS wear protective eyewear.
•
ALWAYS use a rotary blade tool to strip the cable (DO NOT use a bladed knife).
Warning
Failure to obey the following precautions may result in injury or death:
•
Use the proper hoisting grip for the cable being installed. If the wrong hoisting grip is
used, slippage or insufficient gripping strength will result.
•
Do not reuse hoisting grips. Used grips may have lost elasticity, stretched, or become
weakened. Reusing a grip can cause the cable to slip, break, or fall.
•
The minimum requirement is one hoisting grip for each 60 m (200 ft) of cable.
