Chapter 4: Preparing for installation
Preparing for installation
Page
4-5
Preparing for installation
ODU pre-configuration
It is common practice to pre-configure the units during staging before site installation by performing
the following tasks as explained in Configuration Guide.
•
Connecting to the unit
•
Configuring IP and Ethernet interfaces
•
Upgrading the software version and using CNUT
•
General configuration
•
Configuring security
•
Configuring radio parameters
•
Setting up SNMP agent
•
Configuring syslog
•
Configuring remote access
•
Monitoring the Link
•
Configuring quality of service
•
Zero Touch Configuration Using DHCP Option 66
•
Configuring Radio via config file
•
Configuring a RADIUS server
If the units are to be pre-configured during staging, the safety precautions below MUST be observed.
Preparing personnel
In no event shall Cambium Networks be liable for any injury or damage caused during the installation of
the Cambium 450 Platform Family ODU.
Ensure that only qualified personnel undertake the installation of a 450 Platform system.
Ensure that all safety precautions are observed.
Preparing inventory
Perform the following inventory checks:
•
Check that the correct components are available, as described in
•
Check the contents of all packages against their packing lists.
Preparing tools
Check that following specific tools are available, in addition to general tools:
•
RJ45 crimp tool (it must be the correct tool for the type of RJ45 being used).
