CONTROL BOX INSTALLATION
CM9-2 INSTALL ATION AND OWNER MANUAL V.3.1 | 2023.06.01
PAGE 06
FIGURE A
FIGURE C
Drill Hole
FIGURE B
Baseboard
Unscrew
To Remove
Option 1 - Mounting with Included Plastic Hinges:
1. On the back of CM9-2, locate the 4 plastic hinges attached with a Philips screw on each corner.
2. Unscrew the Philips screws and turn the plastic hinges to the desired position and angle (FIGURE A).
3. Tighten the Philips screws to secure the plastic hinges in place.
4. Position the power box on the wall where you want to mount it and mark 4 holes.
5. Drill holes and use wall anchors to mount the power box securely.
Option 2 - Mounting Direct:
1. On the back of CM9-2, unscrew the 4 Philips screws and remove the 4 plastic hinges from the corners.
2. Open the power box and remove the 4 Philips screws (FIGURE B) on the baseboard to disconnect the
circuit board system from the control box case.
3. Drill 4 holes from the marked location (FIGURE C) on the back of the control box case, to create a mount
holes.
4. Drill holes and use wall anchors to mount the box securely, and consider using liquid shield to shield the
mounting holes for added protection.
5. Reinstall the circuit board system (baseboard) back into the case and secure it with the 4 Philips screws.
