Gate Operator Model: CM9-M9-2-DCNB, CM9-M9-2-DCFP, and CM9-M9-2-DCFP.S
SPEED - The gate opening and closing speed can be adjusted by turning the blue knob labeled “SPEED”
on your gate opener circuit board. turning left increases the speed and turning right decreases the speed.
DIP SWITCH FEATURES
CM9-2 INSTALL ATION AND OWNER MANUAL V.3.1 | 2023.06.01
PAGE 13
OFF
ON
DP
ON
TIMER
0
30
10
40
20
50
60
SEC.
DELAY
0
3
1
4
2
5
6
SEC.
SPEED
FIGURE A
FIGURE B
FIGURE C
FIGURE D
Switch
Name
Description
Gate Closing Delay - switch to ON position, turn timer to 1 - 6 seconds (FIGURE C).
Useful for dual gate operators with locks, requiring one gate to close first before the
other, also known as “Bipart Delay”.
Auto Close - automatically closes the gate after a timed delay. Set to ON and turn
the blue TIMER knob anywhere from 1 - 60 seconds (FIGURE B).
Anti-Tailgating System - when On, after a vehicle has cleared the safety loop, the
gate will start to close immediately. If a second vehicle crosses the loop while the
gate is closing, the gate will stop. The second vehicle must get off the loop before
the gate closes completely.
Dual Gate Installation - for the secondary gate operator only, set the #5 SLAVE
switch to ON. If single gate installation, set to OFF.
Mid-Stop - allows the remote control to stop the gate when opening or closing.
Press once to stop the gate, and press the remote again to reverse the gate.
Automatic Close Override - pressing the remote control will override the close timer
before the timer ends, allowing the gate to close early.
Gate Open Direction - set the direction of which the gate opens when
viewed from
inside the property
: Left or Right.
Maglock - turn on if using a magnetic lock. Wire the magnetic lock in the MAG-
LOCK input on the bottom left of the circuit board.
Slow Stop - Allows the gate to come to a slow stop when closing.
