PHYSICAL LIMITS ADJUSTMENTS
CM9-2 INSTALL ATION AND OWNER MANUAL V.3.1 | 2023.06.01
PAGE 21
1. Unscrew the top 2 Philips screws that are holding the front cover in place. Carefully store these screws in
a safe place since this part is not replaceable and may be needed later for reassembly. (FIGURE A)
2. Slide open the top cover panel to gain access to the limit adjust bar. This will expose the mechanism that
controls the limits of movement for the Linear Arm.
3. Locate and loosen the two screws that hold each limit bar in place. By loosening these screws, you can
move the limit bar to the desired position for adjusting the limits of movement.
4. Adjust the limit bar to the desired position based on your requirements. Once you have set the limits as
needed, tighten the screws securely to hold the limit bar in place.
5. After completing the limit adjustment, slide back the top cover into its original position, ensuring that all
components are properly aligned.
6. Reinstall the front cover by carefully placing it back into position and securing it with the two Philips
screws you removed in the first step.
If you are unsure about the adjustment process or encounter any difficulties, it is recommended to seek
assistance from a qualified technician or the manufacturer's support team.
CLOSING LIMIT ADJUST
OPENING LIMIT ADJUST
