6
L < 3000 mm
h
L > 3000 mm
h
valvola
Width up to 3000 mm
50%
of the width
(W)*
75%
of
the
height
(H)
±1
cm
25% of the width
(W)
Width over 3000 mm
(2 heat cost allocators need to be installed)
Position the heat cost allocator against the riser on which the
thermostatic valve is fitted (flow).
*
If there is an odd number of radiator elements, the installation
position is the median of the width, between two elements, closest
to the valve.
75%
of the height
(H)
(±1cm)
In case of the welded mounting kit:
- Strip the paint off the radiator at the points where the stud bolts are
to be welded on.
- Weld the stud bolts in the gap between two ridges. If there is an
odd number of ridges, choose the median position closest to the
valve.
- Cut off the excess part using cutting nippers, as it may damage the
device.
YES
NO
The heat cost allocator
positioning indicator must
ALWAYS be positioned
exactly at 75% (±1 cm) of the
height of the heat emitter.
During installation, make
sure that the arrow ALWAYS
faces up.
75%
of
the
height
(H)
±1
cm
2. INSTALLATION AND MAPPING (to be carried out by the installer)
MONITOR 2.0
If you make a mistake, do not remove the stud bolts already welded
on, as you risk damaging the radiator; cut them at the base as much
as possible.
valve
Heat cost allocator position on radiator
Heat cost allocator position on towel radiator
N.B.
When installation is complete,
the heat cost allocator is automatically activated after about 90 second.
The following appears on the display:
You can now proceed with parameterisation of the heat cost allocator (see page 17).
Welded mounting kit
25% of the width
(W)
