2.0 E
2.0 PULSE
5
Installation of the heat cost allocator/pulse acquirer
Installing the tamper-proof seal
When installation is complete, fit the tamper-proof seal compressing the two tabs and continue as illustrated below:
①
②
STEP 1
Before proceeding with installation, remove
the probe protection (
a
) and the tamper-
proof seal (
b
).
- Depending on the device that has to be
installed, fasten the wires according to the
following pictures:
STEP 2
Install the heat cost allocator/pulse acquirer
hooking it onto the top part of the anchoring
support and pushing downward.
STEP 3
Press down on the bottom part of the heat
cost allocator until it is securely in place.
a
b
a
b
MONITOR 2.0
MONITOR 2.0 E - 2.0 PULSE
MONITOR 2.0 - 2.0 E - 2.0 PULSE
a
b
2. INSTALLATION AND MAPPING (to be carried out by the installer)
STEP 1
Before proceeding with installation, remove
the probe protection (
a
) and the tamper-
proof seal (
b
).
STEP 2
Install the heat cost allocator on the heat
emitter hooking it onto the top part of the
aluminium anchoring plate and pushing
downward.
STEP 3
Press down on the bottom part of the heat
cost allocator until it is securely in place.
Push only the two side parts of
the seal into the heat cost
allocator until it fits into place.
Finally, push in the central
pin of the seal until it fits into
place.
