Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 73
Number of Leases
The maximum number of IP Addresses that will be leased out to units connected to the Viper when the DHCP
server is enabled. It represents the maximum number of DHCP clients that will be able to lease an IP address from
the Viper.
Lease Duration
The length of time in minutes that each IP address will be leased to a DHCP client before it expires and a new lease
is required. Zero (0) minutes means leases do not expire.
Gateway
This is the IP address of the gateway assigned by the DHCP Server. In router mode, the default gateway is the IP
address of the Viper itself. In bridge mode, the default gateway is 0.0.0.0. To override the default setting, enter a
valid IP address to specify the gateway.
Save
— Click Save to save any changes you have made in this tab. See Note below.
Cancel
— Click Cancel to cancel any changes you may have made to any of the settings in this tab.
Note:
If you change any of the above setting in this tab, as indicated by the yellow alert symbol (
), a reset of the
Viper is required before the setting will take effect.
4.4.3.
SNTP
SNTP is the third (from left) tab of the LAN Settings page. To navigate to this tab, select LAN Settings from the main
menu and click SNTP. From this tab you can set parameters for the Simple Network Time Protocol (SNTP).
Figure 47 – LAN Settings – SNTP
SNTP
Client
The SNTP (Simple Network Time Protocol) Client can be enabled or disabled. The default setting is disabled.