Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 97
4.6.2.
VLAN
VLAN is the third (from left; second from right) tab in the Serial page. To navigate to this tab, select Serial from the
main menu and click VLAN. This tab contains configuration for VLAN set up through either or both of the serial ports
(COM or Setup). VLAN configuration settings for both serial ports, Setup and COM, are on this single tab.
Figure 56 – Serial – VLAN
VLAN Configuration (Setup Port or COM Port)
Mode
Both serial interfaces, Setup and COM, operate in VLAN Untagged mode only. In Untagged mode, devices on this
interface are not using VLAN tags. Incoming (ingress) packets are tagged with the port VLAN ID (PVID). VLAN tags
are removed on outgoing (egress) packets. See the Advanced Settings For Serial » VLAN section that follows for
more options.
Port VLAN ID
Sets the Port VLAN ID (PVID)
Advanced Settings
(Show or Hide)
Click
Show
to show advanced settings in the lower part of the tab; click
Hide
to hide the advanced settings.
Save
— Click Save to save any changes you have made in this tab. See Note below.
Cancel
— Click Cancel to cancel any changes you may have made to any of the settings in this tab.
Note:
If you change the Port VLAN ID (PVID) for either serial port, a reset of the Viper is required before the setting will
take effect, as indicated by the yellow alert symbol (
).