Cadex C4000 SERIES, User Manual

Page: 51 / 152

Battery Adapters
Smart Cables
2. Installation
Smart Cables differ from the Smart Adapter in that the
memory chip is embedded in the cable. The cable is
open-ended
and may be terminated with appropriate
battery connectors. Smart Cables are used with a
Passive Adapter.
The Smart Cable must be programmed before it can be
used. Refer to CHAPTER 7 - PROGRAMMING
BATIERY ADAPTERS.
The Battery Adapters can be installed, removed and
reprogrammed
while other batteries are being serviced.
Observe static precautions while installing Battery
Adapters.
Caution
When the Station is open, do not touch the
card-edge connector or gold contacts of Battery
Adapters, as static charge could cause damage to the
m icro-circu it.
When installing and removing the adapters, guide the
adapter into the card-edge connector. Gently press it
down until level, and tighten the screws.
•
•
Be careful
When removing the adapter, loosen screws and gently
lift off the adapter using both hands. Do not use force.
Avoid jamming.
Bad Adap/lnv Type
If the LCD reads "BAD ADAP" or "INV TYPE", remove
and reinsert the Battery Adapter. If the error persists,
turn the unit off, then on again. If neither action clears
the error, the Battery Adapter needs service.
6-4
•