*diagram not to scale
SET UP 3 - CONNECT & LAUNCH
STEP 3.2 - DOWNWIND LAUNCH SET UP
DOWNWIND LAUNCH SET UP
Your kite is now ready to fly
Please see the sections of this manual that relate to safety and make sure you are
familiar with the conditions before getting on the water. Kite tuning tips are located in
this manual under Tuning.
1. Lay the bar 30 meters downwind of the kite so that the wing tips are facing the
control bar (the leading edge of the kite should be facing into the wind). When
setting the bar up downwind of the kite, you must turn the bar upside down before
walking the lines out. This means that as you are looking toward the kite from
behind, the yellow-sheathed lines will be on the right, while the black-sheathed
lines will be on the left.
2. Walk out the steering (outside) lines and using a larks head knot, attach them to
the middle knots on the trailing edge or back bridles (remember, yellow-to-yellow;
black-to-black).
3. Walk out the white de-power (center) lines and slip each knot into the larks head
loops on the corresponding leading edge or front bridles (remember, yellow-to-
yellow; black-to-black). Make sure that the de-power lines do not cross the steering
lines.
4. The lines should not cross each other or be twisted.
5. Your kite is now ready to fly. Please see the sections of this manual that relate to
safety and make sure you are familiar with the conditions before getting on the
water. Kite tuning tips are located in this manual under Tuning.