*diagram not to scale
SET UP 3 - CONNECT & LAUNCH
STEP 3.1 - ATTACHING CONTROL LINES
ATTACHING CONTROL LINES
Once you have completed SET UP 1 & 2, you are ready to connect your control system to
your inflated kite.
NOTE: See "KITE OVERVIEW" as reference
1. With your lines laid out, carry the kite to the end of the flying lines farthest from your
control bar. Make sure the leading edge is facing into the wind.
2 Secure the kite with sand or sand bags. Do not secure kite with anything sharp or
abrasive.
3. You will notice four connection bridles on your kite (two on each wingtip). There are
three knots on each rear bridle and one larks head loop on each front bridle. Utilize the
middle knot on the rear bridle; the other knots are there for tuning purposes.
4. Slip the knot on your yellow-sheathed de-power (center) line into the larks head loop
on the yellow bridle on the left wing tip of the kite. Give the knot a tug to secure.
5. Using a larks head knot on the sheath of your flying line, attach your yellow steering
(outside) line to the yellow bridle on the left wing tip of the kite. Give the knot a tug to
secure.
6. Slip the knot on your black-sheathed de-power (center) line into the larks head loop on
the black bridle on the right wing tip of the kite. Give the knot a tug to secure.
7. Using a larks head knot on the sheath of your flying line, attach your black steering
(outside) line to the black bridle on the right wing tip of the kite. Give the knot a tug
to secure.
