Cabletron Systems FRM, User Manual

Page: 47 / 396

Introduction to Database Configuration 3-11
E On-Line Update IPX Filter Definitions and Applications
–
(Chapter 14) allows updating the FRM with any changes
without rebooting.
F Review Bridge Filter Definitions
– (Chapter 15) displays any
Bridge filters (see next item) that have been configured on the
FRM.
G Configure Bridge Filter Definitions
– (Chapter 15) specifies
parameters for regulation of bridge traffic by filtering MAC
addresses, NetBIOS names, SAP updates, etc.
H Review Bridge Filter Applications
– (Chapter 15) displays
information on any bridge filter applications (see below)
configured on the FRM.
I Configure Bridge Filter Applications
– (Chapter 15) applies
bridge filters to interfaces/filter types/directions.
J On-Line Update Bridge Filter Definitions and Applications
(Chapter 15) allows updating the FRM with any changes
without rebooting.
G On-Line Update Dynamic Routing Parameters
– (misc.) updates
the system memory with any changes that have been made to
routing parameters.
F Configure Async PAD Parameters
– (Chapter 12) defines operating
parameters for devices connected to FRM async PAD ports.
A Review Async PAD Profiles
B Configure Async PAD Profiles
C Review Async PAD Logins
D Configure Async PAD Logins
G Review Model Information – displays the maximum number of
logical connections allowed, and lists the protocols installed, on the
RLPs.
H Configure Bandwidth Allocation Groups – (Chapter 7) defines up
to 16 groups that assign connection priorities to various types of
traffic.
B Configure RLPs (Chapter 5)
A Review RLP Configuration – displays installed protocols and
identifies installed Line Interface Cards.
B Configure RLP – allows installing and removing protocols.
C Display RLP Memory Status – displays a table showing available and
used memory on each RLP.
C Configure Ports
A
Configure RLP Ports – (Chapter 6 through Chapter 12) specifies each
serial port's type, physical interface, and operating parameters.
B Configure LAN Ports – (Chapter 5) specifies an associated MAC
address for the LAN interface.
C X.25 Address Translation Templates – (Chapter 8) displays, specifies,
and tests templates that are applied to incoming and outgoing call
packets for the purpose of translating selected fields of a packet that may
not otherwise be in a compatible format.
A Review X.25 Address Translation Templates
B Configure X.25 Address Translation Templates
C Test X.25 Address Translation Templates
D Configure Logical Ports – (Chapter 8) specifies operating parameters
for logical ports residing on physical frame relay ports.
E Configure IP/LLC2/BRIDGE/IPX Interfaces