C.P.Bourg Bourg Binder 3001, Operator'S Manual

Page: 35 / 51

3. MAINTENANCE
3.1 Preventive maintenance
Due to the advanced nature of the materials used in the binder, the preventive maintenance is
reduced to the level of inspection, cleaning and occasional adjustments.
Warning: Disconnect
the main power before
you perform the
maintenance
Check the ejection path and
cover clamp for particles of glue.
Clean as required, otherwise the
clamps may freeze up and may
blow a fuse.
Use a cloth with spirit
(SOLVOID.RAP N° 9900 107).
Note: Silicone spray
can be used to
stop the glue from
sticking to the mechanism,
but if used, be very careful not
to spray in the glue tank or onto the
drum.This would ruin the glue.
Caution : The glue tank is hot. Use protection gloves to
work around it
Operator Manual
Page 9 - 35
Initial issue: 12/00
Latest revision: 11/01
1
2
5
6
7
8
8
9
3
4
Daily Weekly
1
Vibrating
table
X X
2 Dust bag X
Each time you change the dust bag check for stuffing in
the milling housing and for paper strips in the bag. If
the number of paper strips is excessive, call for
service
3
Milling
housing
X X There should be no stuffing in the milling housing
4 Glue tank X X Purge glue
Check the glue for quality and for oxidation. Refill by
operator. Call ingeneer for replacement of glue
5 Suction cup X X Replace as necessary
6
Cover nipping
plate
X X Check state Teflon covering
7
Evacuation
guide
X X Check from the top with clamping station fully open
8 Nippers X X
9
Rear clamp
guard nipping
station
X X Remove glue strings
Replacement Comment
Frequence
Ref Description Cleaning