iNetVu New Generation Service Manual
Page 33 of 53
C-COM Satellite Systems Inc.
3.7. Replacing and/or Adjusting the Elevation Sensor’s
3.7.1. Elevation Tilt Sensor
1.
Locate and disconnect the Elevation Tilt Sensor. Remove the (4) screws securing the sensor
to the elevation pulley.
2.
Install the new sensor using low strength loctite in the same orientation as seen below. The
longer screw is located at the P-Clip. Ensure the wire is looped correctly, and is routed clear of
any obstructions during full motion of the EL Axis. Reconnect the cable to the harness.
Platform 1201
Platform 981/755
3.
Congratulations you have successfully replaced the elevation tilt sensor.
3.7.2. Elevation Stow and UP Sensor
Note:
To perform these steps you will be required to move the antenna on Elevation
1.
Lower or raise the antenna so that the sensor target lines up with the sensor.
2.
Disconnect it from the internal harness. Loosen the nut and unscrew the sensor out.
P-Clip Use Longer
Screw here
Sensor Target
P-Clip Use
Longer Screw
here
