BYOU BEAUTY, Instructions And Recommendations For Installation And Use

Page: 8 / 28

8
Fig.8
Choice of installation measurements - 2
As an example, let’s suppose that the measurement M detected
on the leaf is 35 mm.
The value 35 is inserted in the column M and table 1 is com-
pleted, calculating the different values Y:
Tab. 1
S + M = Y
40 mm 35 mm
75 mm
97 mm 35 mm 132 mm
117 mm 35 mm 152 mm
121 mm 35 mm 156 mm
135 mm 35 mm 170 mm
155 mm 35 mm 190 mm
We therefore find the opening angle of the leaf. Let’s suppose
that the angle detected is 95°, the reference table is that for the
angles from 90° to 100°.
from 90° to 100°
Y X
100 mm 140 mm
110 mm 140 mm
120 mm 140 mm
130 mm 130 mm
140 mm 120 mm
150 mm 120 mm
Among the values recommended in this table, note that the
Y:130 measurement is the nearest to the measurement of 132
mm in table 1.
Our installation measurements are:
Y X S
130 mm 130 mm 97 mm
Make note of these values for positioning of the brackets
BTY.1
Adjustable brackets BTY.1
Using the adjustable brackets BTY.1 it is possible to install the
BEAUTY gear reducer with different installation measurements,
without having to make cuts and perform welding.
There are two holes in the bracket, both used to fix the gear
motor.
Figure 8 shows the main positions with relative measurements,
both for hole A and for hole B.
Select the position that corresponds to position “S” calcu-
lated in Table 1 of the “Choice of installation measurements”
paragraph.
The positions 1 and 2 do not modify the value of the X meas-
urement, the fixing gear motor hole corresponds to the central
axis of the bracket.
The positions from 3 to 8 change the value of the X measure-
ment.
With reference to the previously described example, the meas-
urement S of 97 mm requires the position 6.
Note that in this position the measurement X is modified.
It will be necessary to add 72 mm to the measurement X pre-
viously calculated in order to have the new bracket-fixing axis.
A
B