20
Resetting the control unit (Res)
This function annuls all settings made, taking the control unit back to the initial conditions.
It also deletes the settings of the autostart procedure.
NOTE: Any remote controls memorised in the radio receiver are not deleted.
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [
5
] until the Res function is displayed.
PMOT
RES
2
Press and hold [PGM], the RES message starts to flash quickly.
3
Release the [PGM] button when the PRG message is displayed.
The control unit is now taken to factory values.
PRG
4
To go back to the programming menu, press the [PGM] and [
5
] buttons at the same time.
To exit programming, remove the power supply or wait for 60 seconds.
PGM+
5
Selection of the opening/closure speed (Sld)
If the leaves are particularly heavy, this function can be used to reduce the movement speed.
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [
5
] until the Sld function is displayed.
PMOT
Sld
2
Press the [PGM] button to enter the Sld regulation.
The display shows the current value of the Sld parameter.
Use the [
5
] key to select one of these values:
ON reduced speeds
OFF standard speed (default)
on
off
3
Confirm the desired value using the [PGM] key, the display shows PRG.
PRG
4
To go back to the programming menu, press the [PGM] and [
5
] buttons at the same time.
To exit programming, remove the power supply or wait for 60 seconds.
PGM+
5
Condominium function (IBL)
If used in condominiums, it may be preferable that further commands given during the opening phase are ignored.
This function can result useful if many users are involved, in a way to prevent several opening commands, given at the same
time, causing the movement to stop.
1
Press the [PGM] button to access programming or if the control unit is already in the programming
menu, press [
5
] until the IBL function is displayed.
PMOT
IBL
2
Press the [PGM] button to enter the IBL regulation.
The display shows the current value of the IBL parameter.
Use the [
5
] key to select one of these values:
ON IBL mode activated
OFF IBL mode deactivated (default)
on
off
3
Confirm the desired value using the [PGM] key, the display shows PRG.
PRG
4
To go back to the programming menu, press the [PGM] and [
5
] buttons at the same time.
To exit programming, remove the power supply or wait for 60 seconds.
PGM+
5
Summary of Contents for BEAUTY
Page 27: ......
