28/36
2021/03 - Version: B Code : 37371
HOTLINE
WOODEN POOLS
BWT myPOOL
POOL’N BOX
Put the duckboarding modules in position over the box; the hole corresponding to the lock must be located
in the centre of the pool width. Using 12 countersunk screws 4 × 35 from bag I, attach the duckboarding
hinges to the coping on the box side (
Figure 24
) making sure that the coping and duckboarding are correctly
aligned.
8.2.2 Installing the lock on the box
The service hatch locking mechanism (bag I) is comprised of a key lock, a lock cam to be mounted on the
end of the barrel, and a striking place to be fastened to the wooden supporting brace.
•
Unscrew the hex nut on the barrel; remove the hex screw from the end of the barrel and thread the
o-ring onto the barrel ;
•
Push the lock barrel fully into the 20 mm diameter hole in the duckboarding. Replace the hex nut
underneath the duckboarding and tighten it ;
•
Place the lock cam on the end of the barrel, such that it is oriented toward the wooden supporting
brace when the lock is closed. Replace and tighten the hex nuts;
•
Fasten the strike plate to the vertical surface of the closest reinforcing brace using 2 A2 SS hinge
screws 6 × 20 (bag D) (
Figure 26
), approximately 20 mm from the top of the supporting brace, such
that the cam is positioned under the lip of the strike plate when the hatch is locked
Figure 28 – Lock and cam
9.
SAFETY
For your safety, and that of you children, you should read the safety instructions carefully and comply with
all points. Safe use of an POOL ‘N BOX JUNIOR requires adherence to all safety instructions set out in
this assembly, maintenance and operation manual..
Before entering the pool, each person should wet the back of their neck and their arms and legs to avoid
thermal shock.
9.1
Filtration pump and electrical supply safety
The electrical panel power line must be protected at the head of the line by a 30mA RCD. For the installation
to comply with the NF C15 100 standard, the box must systematically be locked unless access to the
filtration group is required for an intervention.
If the filtration pump begins to leak, switch it off immediately.
Check the filtration cable regularly for damage. For electrical safety reasons, the filtration cable cannot be
replaced.
Do not expose the pump to temperatures below 0°C.
To avoid damage to the motor, never let the pump run dry. Never pull the filtration by its cable.
9.2
Safety of children
Your POOL’N BOX JUNIOR is suitable for users aged 3 years and older. The risk is at its greatest when
children are less than 5 years old. Teach your children to swim as early as possible.
