BWT OCTO +450, Installation And Operating Instructions Manual

Page: 9 / 44

9/44
2020/09- Version: L Code : 97112223
HOTLINE
BWT myPOOL TROPIC WOODEN POOLS
6. ASSEMBLY OF THE OCTO POOL STRUCTURE
3
Ø 505 300 cm Ø 505 300 cm
Ø 414 250 cm Ø 414 250 cm
Modèle D1
OCTO 414 379 cm
OCTO 505 470 cm
B
F
A
G
Before you begin, familiarise yourself with the
nomenclature enclosed in the “Waterproofing” kit
and the exploded view (at the end of this notice)
that corresponds to your pool.
Determine the final orientation of your pool, by
preference, the skimmers should be oriented
so that they are facing into the prevailing winds.
Skimmers must be mounted on a side that starts
with a type A slat.
While assembling the walls, make sure that each
slat is fully engaged before starting on the next.
You may need to use a hammer and a clamp to
remedy any slight warping of the slats. Do not
strike the wood directly, use the protective brace
(provided).
During assembly, check regularly that the walls are level and the 4 diagonals are equal in length.
To avoid the risk of injury or damage to the liner, take care to eliminate any splinters during and after
assembly.
If you intend to fit your pool with a counter swim treadmill, you will need to incorporate the 2 slats specially
prepared to mount this option.
Fit the 4 half slats (type A - smooth side facing down) together with 4 male/ female slats (type B), grooves
facing down, double tongues facing up (see the detail below).).
4
Fit together the remaining slats (type B) taking care
to position the slat that will hold the return fitting
(type C) and the machined slat (type D) correctly.
The slat that will hold the return fitting should be
positioned over 4 (type B) slats + 1 type A slat in
the case of a skimmer and an autonomous filtration
unit. The return fitting slat should be located just
under the machined (type D) slat which should be
in the last row of slats at this point in the assembly.