BWT OCTO +450, Installation And Operating Instructions Manual

Page: 22 / 44

22/44
2020/09- Version: L Code : 97112223
BWT myPOOL TROPIC WIOODEN POOLS
HOTLINE
Use a small screw driver or punch to pierce the liner at the 4 points marked and fix the flange in position
with the gasket against the liner. Once the 4 corner screws are in place, continue, inserting a screw
through each hole. Avoid over tightening, this could deform the flange. Tighten the screws alternately to
ensure an even and leaktight fit.
50
Cut away the liner inside the flange. Keep the
offcuts for future repairs.
Clip the weir into place, smooth surface facing the
pool. The weir should be able to swing freely.
Mount the skimmer face plate.
The skimmer basket is passed through the skimmer
mouth, swing the weir towards the pool to make
space.
Place the lid on the skimmer. (these parts can be
found in the Pool Fitting skin pack)
In the case of a filtration unit, refer to the installation instructions enclosed with it.
51
Screw the multi- directional eyeball assembly into
the return fitting body. The eyeball should be
pointed left to facilitate the flow of water necessary
for efficient filtration.
(Prior to assembly, apply a layer of silicon grease to
the eyeball and its housing to facilitate its movement
and subsequent removal).
13. ASSEMBLING AND COMMISSIONING THE FILTER GROUP
Before you continue to fill the pool, assemble the filtration group. Refer to the sand filter installation
instructions below and the pump operating instructions. Study the filtration system diagram and the table
below that lists the main components and the composition of the various packs.
CAUTION
The pump power supply absolutely must be protected by a 30 mA RCD mounted upstream from the
installation.
Similarly, follow all the installation instructions set out in the manuals enclosed with the underwater light
and the electrical panel.
The filtration system, like every other electrical device, must be wired in accordance with the standards in
effect in the country of installation (C15-100 in France).
Do not hesitate to call on the services of a professional to ensure that your installation complies with all
regulation in effect.
We strongly recommend that you install the filter below the water level. If the filter is installed above the
water line, there is a risk of deformation due to depressurisation. The maximum acceptable height is level
with the coping. In the event that the filter is installed above the water line, a check vent must be mounted
on the return line and an inspection check valve must be mounted on the suction line (these items are
available from any pool specialist).