BWT OCTO +450, Installation And Operating Instructions Manual

Page: 25 / 44

25/44
2020/09- Version: L Code : 97112223
HOTLINE
BWT myPOOL TROPIC WOODEN POOLS
57
Check that the upper, inner section of the tank is
clean.
Remove the cap from the collector pipe.
Apply a lubrciant (silicon grease) around the top of
the inside of the tank if necessary to facilitate fitting
of the lid.
Lay the lid flat on the tank and press down evenly
on the lid to insert it into the tank.
Once it is properly fitted the lid should touch the top
of the tank and the o-ring should not be visible.
Put the lid ring into position to hold the lid on the
tank.
Rotate one quarter turn by hand only.
An improperly fitted lid could lead to:
• Sand being introduced into the pool
through the return fittingt
• Water flowing through the waste port.
• Water leaks on the tank.
• It is normal for a small amount of water to
flow from the waste port in filtration mode.
The filter lid features 3 ports. Mount the relevant
union on each port:
Port on the lid Union to be mounted
Waste Hose tail, 38 mm
Suction Hose tail, 45 mm
Return Tapped sleeve 1’’1/2 x
male, solvent, 50 mm.
The sand should reach 2/3 of the way up the
filter.
56
58
59